Re: [webmin-l] DHCP + Failover + VRRP

Before this gets answered, I would like to throw out there (my opinion) that this isn't and shouldn't be a Webmin kind of thing.  

 

If you need this amount of redundancy, I would look elsewhere other than an Admin tool.

 

 

 

Dave

 

 

 

From: Filipe Cifali [mailto:[email protected]] 
Sent: Thursday, July 13, 2017 8:51 AM
To: [email protected]
Subject: [webmin-l] DHCP + Failover + VRRP

 

Hi,

I would like to do this kind of setup:

dhcp server 1 delivers IPs and routes 192.168.0.1 to all his machines

dhcp server 2 is a secondary of dhcp server 1 and only delivers IPs and route if 1 goes down.

I understand that it would be needed an keepalive or something else to do VRRP, so the route IP would "float" between server 1 and 2 as needed. 

But I haven't found a module for it, would that be a bad setup or nobody needed this yet?

The decision about doing VRRP of the route IP is because: if server 1 goes down, server 2 can get his route and the internet doesn't stop for the users. 


 

Thanks in advance. 


-- 

[ ]'s

Filipe Cifali Stangler

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

-
Forwarded by the Webmin mailing list at [email protected]
To remove yourself from this list, go to
http://lists.sourceforge.net/lists/listinfo/webadmin-list