Re: [webmin-l] cannot connect to server after install

All is good now.  I did a wipe of the server, reinstall of the OS etc. 
and then a fresh install of virtualmin.  I then rebooted the server and 
virtualmin is good to go.

Thanks.

On 10/19/2017 03:17 PM, Kimberly wrote:
> I just installed virtualmin (latest from the download page) using the 
> automated install and everything check good during the installation.  
> However, when I try to log into the server at the address given by the 
> vitrualmin installation at the end of the install, I get an error 
> message: can't establish a connection to the server at FQD.com:10000 
> where FQD is my fully qualified domain name for the server.  I am 
> wondering if the webserver that virtualmin installs and uses was not 
> started after the installation.  How can I check this and if so, how 
> can I start it at the command line?
>
> I have never had this to happen all the times I have installed webmin 
> or virtualmin.
>
> -K
>
>
> ------------------------------------------------------------------------------ 
>
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> -
> Forwarded by the Webmin mailing list at 
> [email protected]
> To remove yourself from this list, go to
> http://lists.sourceforge.net/lists/listinfo/webadmin-list
>


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
-
Forwarded by the Webmin mailing list at [email protected]
To remove yourself from this list, go to
http://lists.sourceforge.net/lists/listinfo/webadmin-list