Re: [webmin-l] [bug report] webmin gui - binding webmin to non-public lo ip fails
ѽ҉ᶬḳ℠ <[email protected]>
| Newsgroups | gmane.comp.web.webmin.general |
|---|---|
| Message-ID | <[email protected]> |
> I'm surprising that having non-local IPs on the "lo" interface works .. but > even so, Webmin should allow this. > > If you go to Hardware -> Network Configuration -> Network Interfaces, does > that IP show up? The additional lo ips do not show on Active Now, only the last additional ip (172.23.124.98) is showing at Activated at Boot. The system is running iproute2 and ifupdown2, ifupdown is removed. lo config: iface lo inet loopback address 172.23.120.98/32 address 172.23.121.98/32 address 172.23.122.98/32 address 172.23.123.98/32 address 172.23.124.98/32 Output from -> ip a ls lo: 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet 172.23.120.98/32 scope global lo valid_lft forever preferred_lft forever inet 172.23.121.98/32 scope global lo valid_lft forever preferred_lft forever inet 172.23.122.98/32 scope global lo valid_lft forever preferred_lft forever inet 172.23.123.98/32 scope global lo valid_lft forever preferred_lft forever inet 172.23.124.98/32 scope global lo valid_lft forever preferred_lft forever ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot - Forwarded by the Webmin mailing list at [email protected] To remove yourself from this list, go to http://lists.sourceforge.net/lists/listinfo/webadmin-list