Re: [webmin-l] Webmin not reachable
Mahmood Naderan via webadmin-list <[email protected]>
| Newsgroups | gmane.comp.web.webmin.general |
|---|---|
| Message-ID | <[email protected]> |
>1) Is selinux active if yes either set it to permissive and based on log >data create a custom policy for webmin (im not 100% sure for webmin but >virtualmin disables selinux compleetly during install) or disable >selinux altogether. Do you mean that I have to disable selinux during the installation of webmin? >2) check if zone public is assigned to your public interface (public is >just a name and can be assigned to any or no interface). Yes. Please see below # firewall-cmd --get-default-zone public # firewall-cmd --get-active-zones public interfaces: ens192 # ifconfig ens192: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.168.52 netmask 255.255.255.0 broadcast 192.168.168.255 inet6 fe80::3f36:3726:e718:ac10 prefixlen 64 scopeid 0x20<link> ether 00:50:56:bd:65:b5 txqueuelen 1000 (Ethernet) RX packets 7383146 bytes 3546644131 (3.3 GiB) RX errors 0 dropped 1739 overruns 0 frame 0 TX packets 1092081 bytes 549233068 (523.7 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1000 (Local Loopback) RX packets 43883 bytes 24024144 (22.9 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 43883 bytes 24024144 (22.9 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 virbr0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 inet 192.168.122.1 netmask 255.255.255.0 broadcast 192.168.122.255 ether 52:54:00:8e:ba:8e txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 Regards, Mahmood - Forwarded by the Webmin mailing list at [email protected] To remove yourself from this list, go to http://lists.sourceforge.net/lists/listinfo/webadmin-list