Re: WO on Linux (Red Hat)? revisited
"Cheong Hee \(DCIDT\)" <[email protected]>
| Newsgroups | gmane.comp.web.webobjects.admin |
|---|---|
| Message-ID | <[email protected]> |
Hi Philip I have installed successfully using the platform mentioned. However, I really can't recall specifically the reason for the error. My installation was a few months ago, so pardon for being not able to refresh. If I remember correctly, it could be due to "gnutar" or "compress" utility that is being used in Redhat 8.0 . I have an edge on this, as I have started with Redhat 7.2, and it was working fine. But with Redhat 8.0, I have traced back the issue and managed to pin down the problem. You may try it out if it works. Thanks and regards Cheong Hee ----- Original Message ----- From: "Philip Gilliland" <[email protected]> To: <[email protected]> Sent: Wednesday, December 17, 2003 8:42 AM Subject: WO on Linux (Red Hat)? revisited > A While back there were some entries on the list serve about installing WO > 5.2 on Linux 8.0. More specfically, they spoke about the following error: > > INSTALLATION: > Beginning WebObjects 5.2 full installation: > > . Creating WebObjects installation directory ... > . Creating WebObjects' Applications and Frameworks directories ... > . Installing WebObjects Adaptor source ... > install.sh: Error installing the WebObjects Adaptor source. > > > > I am also getting this error. Does anyone out there have a solution for > this error? > > Thank you > Phil > > > _______________________________________________ > WebObjects-admin mailing list > [email protected] > http://www.omnigroup.com/mailman/listinfo/webobjects-admin