Re: Extending Zope2 bin/instance run
Chris Withers <[email protected]>
| Newsgroups | gmane.comp.web.zope.devel |
|---|---|
| Message-ID | <[email protected]> |
On 05/09/2010 15:03, Wichert Akkerman wrote:
> On 2010-9-4 00:43, Chris Withers wrote:
>> On 03/09/2010 17:21, Tres Seaver wrote:
>>>> I am not sure if this is best done in plone.recipe.zope2instance or
>>>> Zope2.Startup.zopectl. They have differing versions of ZopeCmd. Perhaps
>>>> the plone.recipe.zope2instance code should be merged into Zope2's
>>>> original as well?
>>>
>>> I don't know anything about the code in plone.recipe.zope2instance.
>>
>> Yes, and please remember that Plone is not the only consumer of Zope 2,
>> and neither is plone.recipe.zope2instance the only way to deploy Zope...
>
> there is absolutely nothing Plone-specific about plone, and people are
> using it for non-Plone systems as well.
It's an overly verbose throwback to before Zope2 was a properly packaged
package ;-)
I prefer zope2instance, or just using a raw buildout with one of the
templating recipes for your zope.conf, but then I would say that...
Chris
--
Simplistix - Content Management, Batch Processing & Python Consulting
- http://www.simplistix.co.uk
_______________________________________________
Zope-Dev maillist - [email protected]
https://mail.zope.org/mailman/listinfo/zope-dev
** No cross posts or HTML encoding! **
(Related lists -
https://mail.zope.org/mailman/listinfo/zope-announce
https://mail.zope.org/mailman/listinfo/zope )