Re: [Framework-Team] The new Plone 4.0, was Re: Plone 3.5

On May 5, 2009, at 10:57 AM, Hanno Schlichting wrote:

> Hi.
>
> To summarize the feedback from the European time zone, I think that  
> the
> proposal in general meets the favor of everyone.
>
> The controversial issue is the exact version number to use for the
> release. There seems to be broad support for freeing the current Plone
> trunk from a version designator and release a 4.0 release with the
> envisioned scope of this proposal instead.
>
> If I do not get a strong signal or message otherwise, consider this
> proposal changed in this regard.
>
> Hanno


I'm glad I've not been the point of contention on this issue. ;) It's  
an honor to be... I guess at this point it's "nominated".

A quick survey of our integrators on campus shows an agreement with  
the current state of this discussion:
1) Everyone is for a near-future release of the less risky work being  
done in trunk
2) Calling it 3.5 breaks the dot release contract. Go with "Plone 4"  
instead.

Eric

------------------------------------------------------------------------------
The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your
production scanning environment may not be a perfect world - but thanks to
Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700
Series Scanner you'll get full speed at 300 dpi even with all image 
processing features enabled. http://p.sf.net/sfu/kodak-com