BackTalk to Document The Zope Book (2.6 Edition)/Installing and Starting Zope

A comment to the paragraph below was recently added via http://zope.org/Documentation/Books/ZopeBook/2_6Edition/InstallingZope.stx#2-18

---------------

    **Important note: If you installed Zope from an RPM or a another
    "vendor distribution" instead of installing a Zope
    Corporation-distributed binary or source release, the instructions
    below may be not be applicable.  Under these circumstances, please
    read the documentation supplied by the vendor to determine how to
    start your Zope instance instead of relying on the instructions
    below.**

      % Anonymous User - Mar. 25, 2004 6:20 pm:
       I installed zope on Gentoo using using portage (emerge zope). There is no start script, and I cannot find any
       reference for how to start zope without it!

      % Anonymous User - Mar. 27, 2004 10:47 am:
       You're right, there is no script called 'start'. But there is /etc/init.d/zope-2_6_4 to start/stop zope.
       Works quite fine for me.

_______________________________________________
ZDP maillist  -  [email protected]
http://mail.zope.org/mailman/listinfo/zdp