On 2/25/23 10:24, Carsten Haitzler wrote:
> On Fri, 24 Feb 2023 15:47:37 +0100 [email protected] said:
>
>> Hi
>> I use pipewire and wireplumber with enlightenment, not pulseaudio (only
>> libpulse dependency)
>> My default device is headphones, so, i set this choice in e mixer but,
>> it often falls back to speaker. Other mixer issue, I disable audio
>> input but it always falls back to enabled...
>> Arch Linux system
>> enlightenment-git
>> efl-git
>
> this would be a pipewire issue (or deeper down - kernel, udev? some device
> being unplugged and plugged in?).
>
> e's mixer doesn't even remember what audio device was used last - it does not
> try to restore it. it leaves this up to pulse audio. yes - i know you use
> pipewire. from e's point of view, it's talking to pulse audio - so it uses
> libpluse to do that. :) pipewire can emulate pulse in this way so anything that
> deals with pulse can just work with pipewire.
>
>
Well, I didn't know e mixer doesn't remember audio device priority. I
have to know why, sometimes, priority changes. May be because,
sometimes, i launch two X session in same time... I use pipewire-git and
wireplumber-git ; they work fine, much better than pulseaudio in my
case. I have to investigate then I'll report this issue upstream.
Thanks
--
Maderios
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.