Re: [STUMP] Drop the generation of stumpwm.texi

I've been using the pavol contrib for the last couple years and I
absolutely love it and recommend anyone using pulseaudio check it out.
I love how it works well in two different keybinding scenarios. One is
if you bind a single key to say volume up or volume down, like a
hardware volume key. The other is when you binding it say "C-t v" you
can repeat commands without having to type the prefix again, so you
can do "C-t v kkkkkkjjjjjjmm" to turn the volume up several steps,
turn it down several steps, then mute and unmute.

https://gitorious.org/pavol/pavol/

I think I did need "flat-volumes = no" in /etc/pulse/daemon.conf for
it to work, so if you have a problem check that.

Scott


On Tue, Nov 18, 2014 at 10:24 AM, David Bjergaard <[email protected]> wrote:
> "Diogo F. S. Ramos" <[email protected]> writes:
>
>>> Actually this would be very useful to me, I currently use a very hackish
>>> way of controlling pulse audio's volume with these in my stumpwmrc:
>>> (defcommand vol-up () ()
>>>   "Increase the volume from the shell"
>>>   (run-shell-command
>>>    "pacmd set-sink-volume 0 $(printf '0x%x' $(( $(pacmd dump|grep set-sink-volume|cut -f3 -d' ') + 0xf00)) ) &> /dev/null"))
>>> (defcommand vol-down () ()
>>>   "Decrease the volume  from the shell"
>>>   (run-shell-command
>>>    "pacmd set-sink-volume 0 $(printf '0x%x' $(( $(pacmd dump|grep set-sink-volume|cut -f3 -d' ') - 0xf00)) ) &> /dev/null"))
>>
>> Nice.
>>
>>> A more lispy solution would be really awesome!
>>
>> It is "more lispy" just because it uses more lisp expressions.  In the
>> end, it calls `pacmd' and parses its output, just like yours.
> This is still an improvement over my kludge.  I can't even really
> mentally parse what my code does anymore... I just know that when I
> press the vol-up key, the volume goes up :).
>
>     Dave
>
> _______________________________________________
> Stumpwm-devel mailing list
> [email protected]
> https://lists.nongnu.org/mailman/listinfo/stumpwm-devel