Autoit Not running on WinPEx64 bit

Have you guys experienced this?

I use WinPE2005 to build WinPE for both 32 and 64 bits WinPE.

With the 32 bit WinPE, I can run autoit application on it ok.

With the 64 bit WinPE, when I run the same script, it does nothing.

Is there a way to install Autoit by slipstream?

Regards
Sonny Giang

Australia Post is committed to providing our customers with excellent service. If we can assist you in any way please telephone 13 13 18 or visit our website.

The information contained in this e-mail communication may be proprietary, confidential or legally professionally privileged.  It is intended exclusively for the individual or entity to which it is addressed. You should only read, disclose, re-transmit, copy, distribute, act in reliance on or commercialise the information if you are authorised to do so. Australia Post does not represent, warrant or guarantee the integrity of this e-mail communication has been maintained nor that the communication is free of errors, virus or interference. 

If you are not the addressee or intended recipient please notify us by replying direct to the sender and then destroy any electronic or paper copy of this message. Any views expressed in this e-mail communication are taken to be those of the individual sender, except where the sender specifically attributes those views to Australia Post and is authorised to do so.


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/AutoItList/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/AutoItList/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/