Re: Using Visusal Studio to build Rotor

Sajay,

Typically, the VS IDE only works with the .Net Framework version that it
was shipped with (though, you could make VS.NET 2003 work with 1.0 with
some tweaks, if I remember correctly).  I don't think you will be able to
do the same with Rotor.

Robert Hurlbut
http://weblogs.asp.net/rhurlbut

On Fri, 28 May 2004 15:27:30 +0400, Sajay Antony <[email protected]>
wrote:

>Hello Im quite new to the rotor project.
>
>I would like to know if there were any guidelines to configure sscli to be
>build from inside visual studio.
>
>The build environment enables commandline building of rotor.
>
>How could one set up say the vm to be build with visual studio from the
IDE
>so that we can like set up to start debugging and easier file navigation.
>Has anyone tried this out ?
>
>Regards
>sajay

===================================
This list is hosted by DevelopMentor®  http://www.develop.com
ASP.NET courses you may be interested in:

Guerrilla ASP.NET
15 March 2004, in Boston, MA
17 May 2004 in Torrance, CA
7 June 2004, London, UK

http://www.develop.com/courses/gaspdotnetls

View archives and manage your subscription(s) at http://discuss.develop.com