Re: Error with automatic rerun of tests, 2.4.4

Charlie Poole <[email protected]> wrote:

> Hi Brad,
>
> Here's a quick theory, which - if you verify it - might
> save a lot of discussion.

Sorry for the delay, and thanks for the response.

> I'm guessing that at some point in your experimentation,
> you look at the assembly options General page and then
> click OK.

Are you referring to the Tools=>Options=>Test Loader=>General page, or 
the Tools=>Options=>Gui=>General page?  The latter is displayed by 
default when I open up Tools=>Options, and I know I've at least looked 
at the former, but I don't recall ever actually changing anything on 
that page.

Or are you referring to something else?

> There's a bug in that page, fixed in source,
> which causes only one of the buttons to be on at any
> one time - in other words, all the radio buttons on
> the form are treated as a single group.

Now that you mentioned it, I had to go check, and this is indeed the 
behavior I see on the T=>O=>Test Loader=>General page.  I pressed 
"Cancel" instead of OK, though. :)

> If that's the case, we need go no further. Otherwise,
> lets look more closely.

So, the behavior you relate above is now fixed?  When do you expect to 
release that?

In case I was clear (and I see was at least not complete), the behaviour 
I observed was intermittent.  When I'd run the tests manually after a 
failure to run, they would then run automatically for a period of time 
again, until they stopped.  The first couple of times it happened, I 
would look at the options to make sure I'd checked it, but I haven't 
done that since the first day I started seeing this, and it still 
occurred.

Brad 


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/