Re: NUnit-console Command Line Issue

I'm guessing you aren't running the latest release. This was a fix in one of
the last few releases.
 
Charlie


  _____  

From: [email protected]
[mailto:[email protected]] On Behalf Of Brett Martin
Sent: Tuesday, December 18, 2007 6:55 PM
To: [email protected]
Subject: [Nunit-users] NUnit-console Command Line Issue


I'm seeing a strange issue when using the nunit-console.  I have a number of
unit tests that span multiple test assemblies, seven at this point.  If I
run the nunit-console and pass the list of assemblies to it via the command
line, a failed test or tests will not fail the build (I'm using NAnt to
execute NUnit.)  If I create an NUnit project file with the exact same list
of assemblies and pass the project to the nunit-console via the command
line, those same failed tests will cause the build to fail.  
 
Has anyone else observed this behavior?  Any help would be greatly
appreciated.
 
Thanks.

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace

_______________________________________________
Nunit-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/nunit-users