| Newsgroups |
gmane.comp.windows.eccopro |
| Message-ID |
<[email protected]> |
Somewhere near eccoext.exe (depending on where you get it, usually in the same archive file) should be eccoext.eco file, most of information is there even if in a very short form.
Forget about Clones, for now, it’s a little bit tricky and probably you will never need it.
Try Copy As Link Info together with ordinary Paste (I do not know what Paste As Link To Item is for – does not work for me)
allows you to create a link to an item – by clicking the link you go to the item.
Depends & UniqueID, leave it to the future studying, that deals with GTD process (still do not know how to use it).
From: mailto:[email protected]
Sent: Monday, April 18, 2016 07:34
To: [email protected]
Subject: [eccopro] Link & Clone ??
Hi, I've been running Ecco v3 since Windows 95 and I just installed eccoext on Windows 10. Seems to run fine and so far I'm impressed with the new extension.....at least as far as I can figure it out.
Question: When I right click on an item I get a lot of choices I haven't seen before like Link & Clone, EccoExt Flags, Depends & UniqueID. I can't figure them out and they don't seem to do anything. Is there's any documentation that explains this stuff?