| Newsgroups |
gmane.comp.windows.gui4cli |
| Message-ID |
<[email protected]> |
Hello Joseph,
1: Help file, Commands, Various commands, Set
DEBUG ON/OFF/TOGGLE
This will start or stop the debugging output from Gui4Cli. This can also be done by hitting Control-D in any active gui4cli window, or as stated above.
2: not sure about this, i use mostly XP, when there are errors i see it in the output window, should be the same on W7, but others will know :)
Fred.
--- In [email protected], jd <JDuch@...> wrote:
>
> Hello Dimitris & folks
> i am not new to Gui4Cli (Amiga) but am new to Gui4Cli under Windows and to
> wondows 7 as well.
>
> I just downloaded Gui4Cli & installed it.
>
> I have a problem with the debug output.
> 1) can you still set it in a script with "set debug on /set debug off "(did
> not find it in the docs
> 2) under Amiga OS the output gives you warnings when something is wrong with
> the script and Gui4Cli can not open it. Is this no longer the case under
> windows or what else can be the cause that i don't see these warnings (some
> install problem ?)
>
>
> Joseph
> .
>
>
> Beste groeten
> Jos Duchâtelet
> Tel 02/5
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/gui4cli/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/gui4cli/join
(Yahoo! ID required)
<*> To change settings via email:
[email protected]
[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/