Re: Re: Ctl-E not working

Hi Joseph,

From what it says, its not finding the file INSTALL:Util/EdGotoLine.gc

This should be the in gui4cli/util directory.
It is copied there during installation.
Can you check if its there?

Dimitris


On Fri, Dec 20, 2013 at 10:31 AM, jd <[email protected]> wrote:

>
>
> Hello Dimitris
>
> When using Ctl-E the following message occurs
>
> *ERROR* [19:18:57} File: "D:/Gui4Cli/Gui/Spellcheck...
> File not found, INSTALL:Util/EdGotoLine.gc
>
> Ctl-R seems to work OK
>
> Joseph
>
>
> On 10/12/2013, you wrote:
>
> > It may sometimes not work, if the cursor is in a textbox, or textin, or
> > such, because there the control itself "eats" the keystroke.
> >
> > Just click some other control and it should work.
> >
> > Dimitris
> >
> >
> > On Mon, Dec 9, 2013 at 8:49 PM, jd <[email protected]> wrote:
> >
> >>
> >>
> >> Hello
> >>
> >> I am tyring to convince my grandson to use and program in Gui4Cli
> >> I downloaded the latest version (2012) and installed it.
> >> However Ctl-E did not work.
> >>
> >> Suggestions?
> >>
> >> Joseph
> >>
> >>
> >>
> Regards
>
>  
>