Re: Invisible bar

I hadn't thought about multiple configuration files. When I changed to a different one the old Bar .disappeared, but there was a syntax problem which prevented PowerPro showing any bars..  I located the problem, deleted the offending line, made some other deletions and clicked Apply.
 Now this is where I am confused. When I start PowerPro (even by clicking on the pproconf.pcf which corresponds to the Configure PowerPro address) I still get the syntax error message, but when I run  pproconf.exe the changes have been made.
 I've tried stopping and starting PowerPro and rebooting but the message will not go away..