RE: How Xserver build the makefil for dirver?

Thanks for your help.
I have successfully activated the Xserver by following the steps you give.
Thanks a lot.
vichy


-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of
Tim Roberts
Sent: Friday, August 04, 2006 1:19 AM
To: kuo chechun
Cc: [email protected]
Subject: Re: How Xserver build the makefil for dirver?

kuo chechun wrote:

> I just try to do that you show me, ant the server did complain the
> module ABI minor version (7) is newer than the server's version (6).
> Would you please tell me how to -ignoreABI switch?


The -ignoreABI switch is a parameter to the X command that launches the
server.  The method you use depends on how you start the server.  If you
use "startx" from a command line, you can say "startx -- -ignoreABI". 
If you run a version of "xdm" at boot time, you probably have a file
called /etc/X11/Xservers that gives the commands lines.  You can add the
switch there.

-- 
Tim Roberts, [email protected]
Providenza & Boekelheide, Inc.

_______________________________________________
Devel mailing list
[email protected]
http://XFree86.Org/mailman/listinfo/devel