XFree86 for ARM Based Embedded Board
"Kanagesh R" <[email protected]>
| Newsgroups | gmane.comp.xfree86.devel |
|---|---|
| Message-ID | <[email protected]> |
Hello, Usually, for frame-buffer based embedded systems, we use Tiny-X which is more efficient (smaller footprint and easier to configure). I am now working on an ARM based embedded board with a frame buffer and I need to build X11 (Release 7) for this (My end objective is to run KDE on the target board.). I looked up for information on the intenet and at www.X.org and www.XFree86.org but couldn't find anything about cross compiling a full fledged XServer for a frame buffer based system. Most documents are pertaining to building Tiny-X. I have the following doubts: 1. Has the above been achieved before (Cross compiling a full-fledged XServer) for ARM? 2. Are there documents with pointers to go about getting this done? Information would be of great help. Warm regards, Kanagesh -- _______________________________________________ Get your free email from http://www.india.com