Re: ati radeon 8500, dri r200 snapshot driver, X crash - Caught signal 11???

Michel Dänzer <[email protected]>
Newsgroups gmane.comp.xfree86.expert
Organization Debian, XFree86
Message-ID <1038781564.17922.121.camel@thor> 
On Sam, 2002-11-30 at 21:25, jozob wrote:
> I have ATI RADEON 8500, 64 MB DDR....."powered by ati".
> Hi, i have installed the newest snapshot R200 dri drivers,

You should report problems with these to one of the DRI lists.

> i have also installed the extras. But when i start X, it shows screen and 
> cursor, but then immediately stops and shows me:

[...]

>    *** If unresolved symbols were reported above, they might not
>    *** be the reason for the server aborting.
> 
> Fatal server error:
> Caught signal 11.  Server aborting

Just a guess: can you try without the freetype module?


-- 
Earthling Michel Dänzer (MrCooper)/ Debian GNU/Linux (powerpc) developer
XFree86 and DRI project member   /  CS student, Free Software enthusiast
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.