Re: XFree86 -configure fails

sashan wrote:

>On Sun, 2002-12-08 at 10:31, Mark Vojkovich wrote: 
>  
>
>>On 7 Dec 2002, sashan wrote:
>>
>>    
>>
>>>Attached are the results of XFree86 -configure (configure.txt), scanpci
>>>-v (scanpci.txt) and the log file. Please can someone help or advise how
>>>to go about making changes to the header file mentioned (see
>>>configure.txt)
>>>
>>>      
>>>
>>   That card wasn't supported 4.2.0.  It's supported in CVS.
>>If you don't want to build a CVS server, the module on my web
>>
>>    
>>
>Ok, thanks, but I ended up downloading the source anyway. Didn't realize
>it was so huge. However now I have a problem with xkb. When I type 
>XFree86 -xf86config /root/XF86Config.new 
>
>it fails load xkb. See the attached file. 
>
>I had a look in /etc/X11 for xkb and its a broken symbolic link when it
>should be a directory. 
>
>The commands I typed to compile and install the the server were: 
>make World >& world.log 
>make install >& install.log 
>  
>


Just to follow up on this issue I reinstalled RH and downloaded the 
source for the drivers from NVidia, recompiled and installed them and it 
all works. The refresh rate is up to 85hz and not 60Hz like before. 
XFree86 -configure still fails (since its v4.2.0) but it doesn't matter 
that much anymore.

>  
>