Re: 3D Labs R3 cards
[email protected] (Måns Rullgård) 25 Dec 2002 11:35:00 +0100
| Newsgroups | gmane.comp.xfree86.expert |
|---|---|
| Message-ID | <[email protected]> |
mel kravitz <[email protected]> writes: > Is the 3D Labs R3 chip supported in 4.2.1 or -current? > cvs of xc../../hw/xfree86/drivers/glint/glint_man shows permedia 3,& R4. > Tried the card in 4.2.1 and i get a messed up screen with the > 'glint'driver. Permedia3 and R3 are the same. I use an Oxygen VX1 board with XF86 4.2.1. No problems there with 'glint' driver. Check your configuration. -- Måns Rullgård [email protected]