Re: Low-Res modes?

Scott Barnes writes:
 > 
 > I also have this problem, on a NM2160.  I've noticed however that if you use the VESA driver these modes will work, so I think it's a bug in the neomagic driver, perhaps related to modeline detection.  Is there any way the neomagic driver could use the VESA mode detection thingy? :)
 > 

For the internal display the driver has certain resolutions hardcoded
to set the timings right. However these modes may work in CRT only
mode.
If you need these low res modes feel free to hack the driver.
After all this is an OpenSource project.

Egbert.