Re: nvidia problems
Dennis Veatch <[email protected]>
| Newsgroups | gmane.comp.xfree86.newbie |
|---|---|
| Message-ID | <[email protected]> |
On Wednesday 04 December 2002 02:17 pm, Ernie Schroder wrote: > Hi There, > I have recently upgraded from an old Savage4 pci vidio card to a Verto > GeForce4 Ti 4200. I have d'loaded and succesfully installed NVIDIA-GLX and > NVIDIA-kernel, both version 3123. I have, to the best of my knowledge > followed the instructions in the README but, AGP will not work. > Could my problem stem from the fact that the OS was installed with the PCI > card and thus AGP was not configured? If I run with the NvAgp option at "2" > or "3" apgart is loaded when I do "startx" but calling "glxgears" hangs the > X session to the point where I can't even get in remotely. I can't even > ping the box. > Attached are my XF86Config-4, XFree86.0.log and glxinfo. > Also, (maybe another hint) XFree86 -configure exits with a fatal error. > scanpci -v shows: > > [ernie@localhost ernie]$ scanpci -v: > Fatal Error: > xf86EnableIOPorts: Failed to set IOPL for I/O > I think you have to be logged in as root in order to run scanpci. If I try the commnad as a normal user I get the same error but do not when done as root. -- Registered Linux User - 193414 Linux Counter, http://counter.li.org _______________________________________________ Newbie mailing list [email protected] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie