Re: x be mop out after upgrade in test of debian, please help

yes , I know the spec of my monitor of kds Xflat 17e
3dforce B-16, 16M  print on my card
HOLTEK
HT27C512-70
A022Z0612-2

my most current config is using xfree86  4.0
after that, startx
it response
(EE) no device detected

it assum my card on pci bus: PCI:01:00:0
maybe that is not correct,

it is in my the only one AGP slot of 645e Max Mainboard

tdfx and did not know what else can do.

I also tried fbdev config
I get :
(EE) A screen must specify the device

at begining boot, gdm ask me to reconfig x, I choose tdfx banshee (first
item in 3 item of tdfx)

of course not work

hope to more advice

highly apprecaite your help and time and effort

sincere Eric
----- Original Message -----
From: "Seneca" <[email protected]>
To: <[email protected]>
Sent: Friday, December 06, 2002 6:52 PM
Subject: Re: x be mop out after upgrade in test of debian, please help


> On Fri, Dec 06, 2002 at 06:50:01PM -0700, eric wrote:
> > ----- Original Message -----
> > From: "Seneca" <[email protected]>
> > To: <[email protected]>
> > Sent: Friday, December 06, 2002 4:17 PM
> > Subject: Re: x be mop out after upgrade in test of debian, please help
> >
> >
> > > On Fri, Dec 06, 2002 at 04:00:46PM -0700, eric wrote:
> > > > after I install xserver_xfree86
> > > > it have dialog window pop out, to configure my system
> > > > I choose xfree86
> > > > then it ask me chip, my agp card is 3Dfx(3dforce-15Mb)(so I choose
tdfx
> > it
> > > > probably is not correct, please reponse)
> > > > then the otehr parameter(I almost hit return or follow this simple
> > example)
> > > > it is not work
> > > >
> > > > how do I re launch that configure chip and x 's program
> > > > I retype apt-get install xerver-xfree86  it say it already newest.
so no
> > > > configure program launch
> > >
> > > dpkg-reconfigure xserver-xfree86
> > >
> > >
> > after I reconfigure by the way you recomand, startx
> >
> > (EE) no device detect
> >
> > and everytime reboot to gdm, it flash 3 times(black screen)
> >
> > I chose tdfx on my card, also leave keyboard feature and option blank(I
only
> > hit return)
> >
> > the other almost default
>
> What is the rest of the output from startx? What is your
> /etc/X11/XF86Config? What happens if you try using xf86config (you
> should know your monitor's specs when using this)?
>
> --
> Seneca
> [email protected]
>
>
> --
> To UNSUBSCRIBE, email to [email protected]
> with a subject of "unsubscribe". Trouble? Contact
[email protected]
>
>