OUT OF RANGE error using X and a new SONY LCD

Hello,

 

I ran into problem while installing X on my computer with a new purchased
SONY monitor
(http://www.sonystyle.com/is-bin/INTERSHOP.enfinity/eCS/Store/en/-/USD/SY_Di
splayProductInformation-Start;sid=Z03gul4cczjgpWAcl93qsRETyEn4XgX5Mlg=?Catal
ogCategoryID=LtAKC0%2eN4WkAAADyCmY8lSwT
<http://www.sonystyle.com/is-bin/INTERSHOP.enfinity/eCS/Store/en/-/USD/SY_Di
splayProductInformation-Start;sid=Z03gul4cczjgpWAcl93qsRETyEn4XgX5Mlg=?Catal
ogCategoryID=LtAKC0%2eN4WkAAADyCmY8lSwT&ProductID=mWMKC0%2eNYdkAAADyB3k8lSwf
&Dept=cpu> &ProductID=mWMKC0%2eNYdkAAADyB3k8lSwf&Dept=cpu)

 

Every time I start X I get the error that my monitor displays "OUT OF
RANGE".

 

I used the 'xfg86config' script to try and pick the lowest HSync and VSync
and it still displayed the error. I looked up in my monitor manual and set
up my own custom HSync and VSync, but the result was the same, the "OUT OF
RANGE" error showed up.

 

I tried to pick the lowest possible resolution and the lowest possible color
and again the result was the same. 

 

So basically I tried all the possible numbering of ranges and none of them
work which makes me wonder if my monitor works with X.

 

While installing X it did not detect my monitor model. XFree86 4.2.1

 

My computer has GForce3 Ti 200 installed using the DVI adapter.

 

I hope I have been descriptive.

 

Thank You