Re: Render API

Yes I was talking X in general not even XFree86 in particular.  Kenton is a
SUN
man and does not acknowledge the presence of XFree86.  I put it up only for
those who are
interested in some generic site, though I will have to make a note of it's
use at some point.

As for render the best place to find out information about it is from the
author himself;
try www.keithp.com, specifically under Keith's Papers.

As for the last piece, the bounce?  I know nothing about that.  My apologies
though
for the inconveniences

Georgina

----- Original Message -----
From: "Eric Christopherson" <[email protected]>
To: <[email protected]>
Sent: Tuesday, September 17, 2002 2:22 AM
Subject: Re: [Render] Render API


> On Wed, Aug 28, 2002 at 12:53:54PM -0400, G O Economou wrote:
> > Look at www.xfree86.org/support.html for the Kenton Lee site.  That
should
> > help you.
> >
> > Georgina
>
> Georgina, thanks for the reply. I'm confused though, since I didn't find
any
> mention of Render on Kenton's site. Did you mean just for X programming?
In
> that case, I already have a page off that site bookmarked, but haven't
> gotten around to reading it yet. Also, I noticed tonight that many of the
> links on there seem to point me back to the start page.
>
> Lastly, I tried sending this to you personally, but the mail was bounced
> back.
>
> --
> Furrfu! r a k k o  at  c h a r t e r  dot  n e t
> _______________________________________________
> Render mailing list
> [email protected]
> http://XFree86.Org/mailman/listinfo/render
>