Re: [PATCH v3] NEWS: Add note about window snapping.

Quoting message written on Saturday 2015-06-20 22:49:51:
> On 06/20/2015 05:11 PM, Josip Deanovic wrote:
> > I have just applied the patch and tested it and something is not
> > right.
> > 
> > Without workspace linking the feature is still working as usual.
> > 
> > With workspace linking enabled I get the window frame created UP/DOWN,
> > depending on the window position but if I decide to stop the snapping
> > action (move the window from the upper/lower border) the window frame
> > would stay and when I release the window it would snap to the border
> > and change its size.
> > 
> > So once the window gets near the upper/lower border and its new frame
> > gets drawn, the only thing I can do is to move the window to the
> > opposite border where window would act just the same.
> 
> I think I've fixed this.  I've just sent a revised patch.
> 
> Doug

I have just tested it.
I have also tested it with and without workspace linking and in
combination with the feature turned on/off.

Everything works as expected it should be safe to apply the patch.


I didn't thoroughly look at the code so I'll just ask...
In case when workspace linking is turned off, is it possible to
make a bit borders/area in which window would snap into a corner
without changing some other Windowmaker code?

While testing the feature I have noticed that it is a bit tricky
to pick a corner. You almost need to pinpoint it and you need to
keep your cursor steady while releasing the button. Otherwise it
could chose to snap to horizontal or vertical border.

-- 
Josip Deanovic


-- 
To unsubscribe, send mail to [email protected].