Re: [PATCH] In the README it is said to run ./configure but there's no such script in the tarball. I wrote instructions to generate a ./configure with libtool and autotools.
"Carlos R. Mafra" <[email protected]>
| Newsgroups | gmane.compw.window-managers.windowmaker.devel |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 7 Oct 2015 at 10:28:22 +0200, Shining wrote: > On Wed, 7 Oct 2015 00:11:28 +0200 (CEST) > BALATON Zoltan <[email protected]> wrote: > > > >> On Mon, Oct 05, 2015 at 11:19:42PM +0200, Shining wrote: > > >>> +libtoolize > > >>> +aclocal > > >>> +autoconf > > >>> +automake --add-missing > > > What about "autoreconf -if"? I think that should work but haven't tried. > > You are right, Zoltan: > > $ autoreconf -if > libtoolize: putting auxiliary files in `.'. > libtoolize: copying file `./ltmain.sh' > libtoolize: Consider adding `AC_CONFIG_MACRO_DIR([m4])' to configure.ac and > libtoolize: rerunning libtoolize, to keep the correct libtool macros in-tree. > libtoolize: Consider adding `-I m4' to ACLOCAL_AMFLAGS in Makefile.am. > configure.ac:5: installing './compile' > configure.ac:5: installing './config.guess' > configure.ac:5: installing './config.sub' > configure.ac:3: installing './install-sh' > configure.ac:3: installing './missing' > Makefile.am: installing './INSTALL' > > If the patch hasn't been committed yet I can write a new one. Just write a new one and I can replace it on the 'next' branch. -- To unsubscribe, send mail to [email protected].