Re: Too many errors from stdin
Benno Schulenberg <[email protected]>
| Newsgroups | gmane.editors.nano.general |
|---|---|
| Message-ID | <[email protected]> |
Hello Roman, Op 23-09-2017 om 14:10 schreef Roman Tereshkov: > I`ve gotta problem with my Nano. The problem occurs when I run MPI programs ?? What are MPI programs? > (even > with just simple send and recv in main function and that`s it). When the MPI job > is done -- I cannot open any of the files using Nano or even Nano itself in this > terminal. Nano opens and closes immediately, and then all I see is just the "Too > many errors from stdin" message. After that I close this terminal, open up > another one and voila -- Nano works perfectly again. It sounds like those MPI programs leave the terminal in a fishy state, with standard input kind of half disconnected. If after running the MPI program and before running nano, you run the 'stty sane' command, does that help? > One good person gave me an advise to use the "strace" tool, but it seems that I > pretty dumb for that um.. so if it hepls, the output is here ~> > https://pastebin.com/Gg6gBBYc Please attach your strace to your email so it will be stored in the archives. If the strace is less than 50K, attach it as is; otherwise gzip it. Benno _______________________________________________ Help-nano mailing list [email protected] https://lists.gnu.org/mailman/listinfo/help-nano