Re: Service entry point debug with condition

Just did a little test with Conditional SEP on RDi 9.6.0.13. (As I said, 
I cannot get SEP debug in RDi 9.8.0.5 to work at all ....)

Anyhoo ... all worked just fine when calling the program from 5250. Set 
the SEP condition on an entry parameter. If condition was met, RDi 9.6 
debug fired up. If condition not met, program ran as normal, (no debug).

Doesn't help you, David - but does prove the conditional SEP will work, 
(sometimes 🙂).

Brian.

On 17/07/2025 16:00, David Gibbs via WDSCI-L wrote:
> On Thu, Jul 17, 2025 at 9:42 AM Brian Parkins <[email protected]> wrote:
>> (I can't get RDi 9.8 SEP debug to work at all. Works fine with RDi 9.6
>> on the same V7.5 server - and all fixes applied. Thank goodness for STRDBG!)
> SEP debug itself works fine (9.8.0.5), it's just a pain when debugging
> these programs because they are being used by a lot of people and it
> would be nice to be able to only activate when I invoke it with a
> specific value passed in.
>
> david
>

-- 
This is the Rational Developer for IBM i   (WDSCI-L) mailing list
To post a message email: [email protected]
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/wdsci-l
or email: [email protected]
Before posting, please take a moment to review the archives
at https://archive.midrange.com/wdsci-l.