Code Coverage questions

I am using RDi's [Version 9.8.0.2 (20240514_1451)] Code Coverage (CC) and 
have two questions:


1. I notice that when I use CC on a SQLRPGLE program, the source is not 
available. Is this normal? Is there a way around it? The main program I am 
using CC with is SQLRPGLE and I cannot see the view that shows the 
executed and non-executed lines for SQLRPGLE programs. Normal RPGLE 
programs are fine.


2. Is there a way to merge the results of one program over two or more 
code coverage sessions? For example, I want to test one program twice, 
with different parameter values, and would like to see both tests merged 
together in CC so I can see in total what percentage of the programs were 
tested over the two [or more] CC sessions. Is this possible?


I have used Code Coverage before, but this is one of the few times where I 
have used it extensively for a project.

Thank you,

Doug



"CONFIDENTIALITY NOTICE:  This e-mail transmission (and/or the attachments accompanying it) contain confidential information belonging to the sender.  The information is intended only for the use of the intended recipient.  If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or the taking of any action in reliance on the contents of the information is strictly prohibited.  Any unauthorized interception of this transmission is illegal under the law.  If you have received this transmission in error, please promptly notify the sender by reply e-mail, and then destroy all copies of the transmission."
-- 
This is the Rational Developer for IBM i   (WDSCI-L) mailing list
To post a message email: [email protected]
To subscribe, unsubscribe, or change list options,
visit: https://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request-+hD5IHI5Xscn3HwCXmMcX9BPR1lH4CV8@public.gmane.org
Before posting, please take a moment to review the archives
at https://archive.midrange.com/wdsci-l.