Re: Problem with MS Windows-based Installation

Thanks, Ralf.  You're right.  It still works fine after I removed (load 
"tex-site").

BTW: I'm using AUCTeX 11.55
                         MikTeX 2.4
                         CVS Emacs 21.3.50.1
                         Windows XP.
--------
Best Regards,
Adam

----- Original Message ----- 
From: "Ralf Angeli" <[email protected]>
Sent: Tuesday, March 15, 2005 4:12 PM
Subject: Re: Problem with MS Windows-based Installation


>* Adam Johnson (2005-03-15) writes:
>
>> I'm using AUCTeX on Windows XP and also in multifile case.  It works fine
>> here.
>>
>> Are you using both tex-mik and tex-site?  If not, try to put the 
>> following
>> sentences in your .emacs.  I can access Yap from main file or sub files.
>>
>> ;; tex-mik is needed for using yap to preview dvi file
>> (require 'tex-mik)
>> (load "tex-site")
>
> This is _not_ good!  tex-mik.el already `require's tex-site.el.  That
> means it will load the file but only if it was not loaded before.
> With your `(load "tex-site")' statement you are not checking if the
> file is already loaded by unconditionally load it _again_.  It would
> be better to remove this line.
>
> -- 
> Ralf
>