Bus error when attempting to run two emacs -nw on 10.1.5

This behavior has been seen on an iBook (14.1", 600MHz PowerPC 
processor, 256MB RAM)

I am currently running a CVS version of Emacs as of 17 June 2002.

When trying to start a second instance of an emacs -nw (in a new 
Terminal window or xterm), the attempt fails with the message 'Bus 
error'.  If I quit the first emacs -nw, it is possible to start emacs 
-nw in the second Terminal or xterm window.

I see this behavior also when .emacs is empty.

I have experienced this behavior in earlier versions of Emacs as well, 
namely the CVS version of 7 June 2002 and also Emacs 21.2 (as far as I 
remember.)

Henrik

--
Below follows output that was generated by M-x report-emacs-bug RET

In GNU Emacs 21.3.50.1 (powerpc-apple-darwin5.5)
  of 2002-06-17 on alouin02.ece.umn.edu
configured using `configure --without-x'

Important settings:
   value of $LC_ALL: nil
   value of $LC_COLLATE: nil
   value of $LC_CTYPE: nil
   value of $LC_MESSAGES: nil
   value of $LC_MONETARY: nil
   value of $LC_NUMERIC: nil
   value of $LC_TIME: nil
   value of $LANG: en
   locale-coding-system: iso-latin-1
   default-enable-multibyte-characters: nil



-------------------------------------------------------
This sf.net email is sponsored by: Jabber Inc.
Don't miss the IM event of the season | Special offer for OSDN members! 
JabConf 2002, Aug. 20-22, Keystone, CO http://www.jabberconf.com/osdn