Re: tramp (2.6.3 nil/nil); tramp rclone enters endless loop

Pieter van Oostrum <[email protected]> writes:

> Hello Michael,

Hi Pieter,

> There was no mount point for anything related to rclone.
> But I found out that my rclone (on MacOS) didn't even have the mount comm=
and.
> So I recompiled it with mount support and now it works.

Thanks for the feedback.

> Would it be possible for tramp to check for this situation?

I have added the following lines to the section "4.20.1 =E2=80=98rclone=E2=
=80=99 setup"
in the Tramp manual:

--8<---------------cut here---------------start------------->8---
Check, that your =E2=80=98rclone=E2=80=99 program is compiled with mount su=
pport.
Call =E2=80=98rclone mount=E2=80=99 and check for an error message.
--8<---------------cut here---------------end--------------->8---

> Thanks for your help, and sorry for the confusion.
>
> With kind regards,
> Pieter van Oostrum

Best regards, Michael.