Re: TRAMP cannot connect to remote + proxyjump

Rishub Nagpal <[email protected]> writes:

> Dear tramp-devel,

Hi Rishub,

> **Apologies if this is sent twice, I was not subscribed to the list
> before sending this message and did not see it on archives so I assume
> it was silently dropped.**

[email protected] is a moderated mailing list. Messages from
non-subscribed people must wait for approval from a
moderator. Meanwhile, your first message has arrived as well.

> I am trying to connect to a remote that is behind a proxyjump in my
> SSH config. It is described as follows:

See the Tramp manual at (info "(tramp) Ssh setup")

--8<---------------cut here---------------start------------->8---
   =E2=80=98tramp-use-connection-share=E2=80=99 should also be set to =E2=
=80=98nil=E2=80=99 or
=E2=80=98suppress=E2=80=99 if you use the =E2=80=98ProxyCommand=E2=80=99 or=
 =E2=80=98ProxyJump=E2=80=99 options in your
=E2=80=98ssh=E2=80=99 configuration.
--8<---------------cut here---------------end--------------->8---

I suppose this is the reason of your problem.

> Any ideas on what to do? Will be happy to provide additional logs or cont=
ext
> Rishub

Best regards, Michael.