Re: Adding subdirectories to load-path?

Hauke Fath <[email protected]> writes:

> The xemacs packages come with compiled elisp files; when I patch source 
> files, I need to recompile them. Now, pkgsrc is about building from 
> source. In the general case, somebody will install an xemacs, and then 
> install xemacs-packages to use with it. During the install process, the 
> elisp files will be in some arbitrary place, but not where the 
> (previously compiled) xemacs expects them. 

So this is still a bit too general to give a specific answer.  But the
XEmacs manual has a section on "Startup paths" that tells you numerous
ways of influencing where XEmacs looks for elisp stuff.

-- 
Regards,
Mike