default for opening files read-only or read-write
Steve Whitlatch <swhitlat-r/[email protected]>
| Newsgroups | gmane.emacs.xslt-process.general |
|---|---|
| Organization | Steve Whitlatch, Inc. |
| Message-ID | <[email protected]> |
Hello everyone, I installed xslt-process_2.2 last week and just now started using it. I'm afraid I must have chosen to open files by default in debug mode. Either that or the installation default is to open files read-only in debug mode (XSLTd). I know about toggling debug mode on/off, but I'd like to open all files read-write by default, not in debug mode. How can I do that? Perhaps I must reverse something I did previously. Thanks, Steve Whitlatch ------------------------------------------------------- The SF.Net email is sponsored by EclipseCon 2004 Premiere Conference on Open Tools Development and Integration See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. http://www.eclipsecon.org/osdn