Re: VECTOR: ANNOUNCE: New Amplifone HVU PCBs (not modded WG)

Yeh, now that you mention it, they may have gotten it from ArcadeShop.  
However,
I hunted the HV PCB over previously and couldn't find a B+, but did find 
some
areas where parts would go.  Hmmm...   I wonder if that got left off.  I 
tried to find
a picture on ArcadeShop to compare to, but couldn't.  :(   I'll look 
again at the HV
unit.

Scott C.

[email protected] wrote:

> Hi Scott, that must have come from Arcadeshop or Fred/Tom, since 
> nobody has received a real Amplifone replacement yet.  Sounds like a 
> modded WG6100, but in either case, there is a B+ adjustment on the 
> PCB.  One is marked for B+ and one for Freq.  Turn up the B+ VERY 
> slowly, turn it too far and you'll blow the fuse and a transistor.
>  
> Dave
>  
> +++++Ask me about Retrocade 30-in-1 MultiPac kits for Midway Pac Man 
> and Ms Pac Man boards and same kit already attached to a new JAMMA 
> PCB. Also we now have purchased the rights to WG6100 (Tempest, etc) 
> new deflection boards and HVU boards. Also HVU boards for Amplifone 
> (Star Wars). These are version 2 with no extra wiring or mods 
> necessary. Ask about Star Wars overlays and new cabinets for Midway 
> cocktail, upright, mini, Dragon's Lair, Williams, Golden Tee Fore, and 
> Ultra-MAME++++