RE: VECTOR: Cocktail BZ

I'll chime in with the couple pics I snapped at CAX in 2002:

http://www.joesarcade.com/joem/battlezone_cocktail.JPG
http://www.joesarcade.com/joem/battlezone_cocktail_top_glass.JPG

Does the one you found have the top glass?  That and the CP's I think would
be the unavailable pieces.

Joe

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Tom McClintock
> Sent: Friday, July 08, 2005 10:15 AM
> To: [email protected]
> Subject: Re: VECTOR: Cocktail BZ
>
>
> Every part is available? Considering there is only one other known
> cocktail Battlezone which is a prototype, seems unlikely.
>
> Yeah, definitely get it!
>
> picture link:
> http://www.ionpool.net/arcade/cax_2000/battlezone_cocktail.jpg
>
>
>
>
> tm
>
> Scott Caldwell wrote:
> > Pete,  I don't know what that board is, but please pick-up that game
> > and restore it.  Every part is available, assuming the joysticks are the
> > same, except the lid (not sure if you mean the wood or glass or both),
> > but that can be fabricated.
> >
> > Scott C.
> >
> > Peter Pan wrote:
> >
> >> I may have located a cocktail BZ but it's missing a
> >> few parts - both boards, PSU, monitor, one set of
> >> joysticks and the lid. Ok, so I have a box on legs
> >> with a wiring loom, 1 1/2 coin mechs and two
> >> joysticks.
> >>
> >> There is one possible saving grace, it seems to have a
> >> small daughter board that is wired into the joysticks.
> >> Anyone know if and what the extra hardware for the
> >> cocktail version is/does?
> >>
> >> Pete.
> >>
> >>
> >>
> >>
> >
> >
> ------------------------------------------------------------------
> ---------
> > ** Unsubscribe, subscribe, or view the archives at
> > http://www.vectorlist.org
> > ** Please direct other questions, comments, or problems to
> > [email protected]
> >
> >
> >
>
> ------------------------------------------------------------------
> ---------
> ** Unsubscribe, subscribe, or view the archives at
http://www.vectorlist.org
** Please direct other questions, comments, or problems to [email protected]