Re: VECTOR: WG K6100 Troubleshooting

accuracy of the values?? this is eletronics!!!  the voltage should be whitin
10% but!
If ur 25volts low or high then all the volt will be lower or higher it comes
down to....
 if theres 1v and there sould be 0v then theres likely to be a fault
fault finding is a skill!!  these no EZ fix..
rember that theres two channels to compear to. X and Y see if the voltages
are the same in each channel.

i hope this helps

----- Original Message ----- 
From: "Chris Loggans" <[email protected]>
To: <[email protected]>
Sent: Thursday, July 29, 2004 4:38 PM
Subject: VECTOR: WG K6100 Troubleshooting


> Has anyone ever used the voltage readings listed at
> different points on the schematics for
> troubleshooting?  Recently, I've been trying to
> troubleshoot a K6100 P314 deflection board that's
> being more difficult than most I've worked on.  I
> tried using the schematic voltages for comparison for
> the first time.  Most were pretty close, but some were
> off much more than I'd expect them to be so I'm trying
> to determine if I've found a problem or not.  Can
> anyone comment on the accuracy of the values?
>
> Thanks,
> -Chris
>
> --------------------------------------------------------------------------
-
> ** Unsubscribe, subscribe, or view the archives at
http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
[email protected]
>