RE: VECTOR: Battlezone problems

Jeff, what about your BZ? Does it work now?

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of vernimark
> Sent: venerdì 1 ottobre 2004 4.22
> To: [email protected]
> Subject: RE: VECTOR: Battlezone problems
> 
> 
> If 244 works fine it could be the same problem I had with 
> Star Wars Coin ground must be short-circuited with general 
> ground and all ground and rtn pins on both connectors must be 
> short-circuited with the ground (i.e. pins N and 12 on vector 
> generator PCB) Marco
> 
> > -----Original Message-----
> > From: [email protected]
> > [mailto:[email protected]] On Behalf Of Hendrix, Jeff
> > Sent: giovedì 30 settembre 2004 14.57
> > To: [email protected]
> > Subject: RE: VECTOR: Battlezone problems
> > 
> > 
> > I was looking at that last night. The signal is good to the
> > inputs of the 74244, but I didn't take the time to get a 2nd 
> > probe and trigger on the chip select to see how the output 
> > behaves. The test switch does work correctly, and it goes 
> > through the same 74244. And the dip switches work correctly, 
> > so the bus is fine.
> > 
> > -jeff
> 
> 



---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to [email protected]