RE: VECTOR: G80 non-conversion connectors
"Christopher X. Candreva" <[email protected]>
| Newsgroups | gmane.games.arcade.vector |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 18 Mar 2005, Joe wrote: > The Star Trek that I have plugs directly into the board set. No > fingerboard or top to the cage. I also have an extra top with I hate Sega. Page 104 of the dedicated manual shows three (what appear to be) molex connectors J1, J2, and J3 mounted on a bracket on the outside of the card cage: http://www.westnet.com/~chris/arcade/ST-p104.gif Page 132, the cabinet wiring diagram, shows these three plus P9 for the volume control assembly. http://www.westnet.com/~chris/arcade/ST-p104.gif If the dedicated cage doesn't actually have these, but sends the wires in to connect directly to all the cards in the cage -- then, uh, I dunno, I'll do something else. For those keeping score :-) The conversion kit puts a card-edge connector in the top cover of the card cage, all cabinet wires solder to a finger board, and that plugs into the top. ========================================================== Chris Candreva -- [email protected] -- (914) 967-7816 WestNet Internet Services of Westchester http://www.westnet.com/