Re: VECTOR: Star Wars - Scale Test

Check the scaling signal. If it's wrong, make sure there are no stuck bits
on the input to the dac.
-Mark

On Mon, Mar 21, 2005 at 09:19:18PM +0000, Phil Morris wrote:
> Has anyone come across this problem before on a Star Wars AVG board - go 
> into test mode and bring up the Scale Test (Linear). This should draw a 
> smoothly shrinking box - however on my own AVG board though this doesn't 
> happen, instead it draws a large box, then a few seconds later a much 
> smaller box, then a few seconds later a much smaller box, etc. In other 
> words the 'in between' boxes aren't being drawn.
> 
> I thought this would be a fault in the scale circuit, yet I can find 
> nothing wrong there whatsoever or, for that matter, in the circuit which 
> that feeds.
> 
> Any tips please anyone? What am I missing?
> 
> 
> Thanks,
> Phil
> 
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to [email protected]