Re: VECTOR: Star Wars - Wobble Vision

Thanks for the info... I've not finished working on it yet...I need to do a
few upgrades to the monitor and arII psu.

I had gone throught the faq and read the deflection board section (which is
where I thought the problem was) today I looked at the HV section and one of
the faults listed matched mine.... so basically I replaced some of the
capacitors in the hv cage with what I had around, and now the picture is
nice and crispy (even though its a the WG monitor)... excellent result..

I also need to setup the monitor properly and go throught the adjustment
procedure.

Ps... I'm also looking to make a few pcb's up for the ESB conversion (wont
be a switchable multigame) based on the esb conversion article on the net
with the slapstick chip programmed into the 22v10 Gal.  Not looking to make
any money out of it - it will be the supply of a bare pcb - you sort the
rest out - probably for $25 or something not costed it out yet (looking at
getting 10 made)  but if anyone is interested, please give me a shout.

Thanks for the help / info guys...

Regards,
Colin


----- Original Message -----
From: Marc Alexander <[email protected]>
To: <[email protected]>
Sent: Tuesday, March 22, 2005 11:43 AM
Subject: Re: VECTOR: Star Wars - Wobble Vision


>
> Here's an old post of mine, I successfully did this to WG and Amplifone
> Star Wars monitors, and it removed the remaining screen wobble,
> hope it does something for you...
>
> Below that is an old post about modding the Asteroids AR board,
> which can be cross referenced to the AR/II board in Star Wars also,
> though the part/pin numbers may be different?
>
> Cheers,
> Marc