Re: VECTOR: SW monitor prob...

I have a HV probe,
 its what i used to discharge the monitor, so i could re-cap it. What 
voltage should i set it to ?





Pinx

p.s.   Col, any parts you have would be much appreciated, also nice to see 
you got the ESB working    :)


----- Original Message ----- 
From: "Christopher X. Candreva" <[email protected]>
To: <[email protected]>
Sent: Friday, April 01, 2005 8:22 PM
Subject: Re: VECTOR: SW monitor prob...


> On Fri, 1 Apr 2005, Pinx wrote:
>
>> "blooming" and so i have just re-capped the HV section, but i still have
>> the problem. Is there anything else on the HV board i should replace to
>> cure this problem ?
>
> Re-capping isn't really a fix for blooming.  Blooming comes from voltage 
> in
> the HV section. The simple way to check that is with a HV probe, which can
> be had for under $20 on e-bay usually.
>
> If it is low, it can be adjusted, the pot may have just slipped.
>
> ==========================================================
> Chris Candreva  -- [email protected] -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at 
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to 
> [email protected]
>