Re: VECTOR: Re: G05 and q502
Rodger Boots <[email protected]> Tue, 10 May 2005 04:24:08 -0500
| Newsgroups | gmane.games.arcade.vector |
|---|---|
| Message-ID | <[email protected]> |
Hmmm, manual I looked at has D504 being an 1N914 diode at the junction of C508, C509, & D505. Either being shorted or open would kill the spot killer. D507 is the LED. Maybe I have a different manual. [email protected] wrote: >"Poor brightness with retrace lines could mean a defective D504, or >perhaps the “Z” signal wire is not connected properly to the base >of Q504." > >According to the manual, d504 is the Red LED. How does a >defective LED cause retrace lines? > >-tom > >--------------------------------------------------------------------------- >** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org >** Please direct other questions, comments, or problems to [email protected] > > > > --------------------------------------------------------------------------- ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org ** Please direct other questions, comments, or problems to [email protected]