Re: VECTOR: Looking for p/n for neck board connector (Amplifone)

Are there any markings on the original that would suggest manufacturer 
or part number?



[email protected] wrote:

> As some have heard, I have the 2nd generation HVU board replacement 
> for the Amplifone monitor.  This is not the WG modded to kinda work, 
> but a new board that is the same size as the original Amp.  What I 
> need is a source for the neckboard connector.  I can't find any good 
> info about APCO who apparently made the original part for the 
> Amplifone.  Anybody have suggestions?I am going to dig out some old 
> tube rejuvenators that I have and see if any connectors are 
> compatible, but wasn't sure if anybody had info.
>  
> Thanks
>  
> +++++Ask me about Retrocade 30-in-1 MultiPac kits for Midway Pac Man 
> and Ms Pac Man boards and same kit already attached to a new JAMMA 
> PCB. Also we now have purchased the rights to WG6100 (Tempest, etc) 
> new deflection boards and HVU boards. Also HVU boards for Amplifone 
> (Star Wars). These are version 2 with no extra wiring or mods 
> necessary. Ask about Star Wars overlays and new cabinets for Midway 
> cocktail, upright, mini, Dragon's Lair, Williams, Golden Tee Fore, and 
> Ultra-MAME++++