Re: torcs compilation problem

Hi

TORCS 1.2.4 is pretty old, use 1.3.6 if possible. If you want/need to 
use 1.2.4 read this:
http://sourceforge.net/p/torcs/mailman/message/30193739/

Hope this helps.

Kind regards

Bernhard


On 08/12/2015 09:48 AM, Dino David wrote:
> Hi,
>
> I really appreciate your tutorial.
> I have some problem with the compilation in the Bulding TORCS section.
>
> I am using this simulator to fetch the parameters like speed and send it
> to micro controller unit via CAN bus.
>
> torcs version 1.2.4 (tutorial was available )
>
> Console output :
> checking for sin in -lm... no
>   "configure: error: Can't find libm. Please check config.log"
> I have attached config.log in this file..
>
> Operating system "Linux Dino-Ubuntu 3.16.0-30-generic #40~14.04.1-Ubuntu
> SMP Thu Jan 15 17:45:15 UTC 2015 i686 i686 i686 GNU/Linux"
>
> Output of glxinfo -l is attached in this mail
>
> File /var/log/XFree86.0.log file is not present..
>
> I kindly request you to help me to sort out this issue.
>
> Thanks in advance,
> Kind Regards,
> Dino David.
>
>
>
> ------------------------------------------------------------------------------
>
>
>
> _______________________________________________
> Torcs-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/torcs-users
>


------------------------------------------------------------------------------